Hitachi CR 18DL Mode D'emploi page 20

English
(2) Push the lever in the direction of the arrow mark
shown in Fig. 8 marked on the lever.
(3) Insert the saw blade all the way into the small
slit of the plunger tip with the lever pushing.
You can mount this blade either in the upward
or downward direction. (Fig. 9, Fig. 10)
(4) When you release the lever, the spring force will
return the lever to the correct position
automatically. (Fig. 11)
(5) Pull the back of the saw blade two or three times
by hand and check that the blade is securely
mounted. When pulling the blade, you will know
it is properly mounted if it clicks and the lever
moves slightly. (Fig. 12)
CAUTION: When pulling the saw blade, be
2. Dismounting the blade
(1) Turn on and off the switching trigger several
times so that the lever can jump out of the front
cover completely. Thereafter, turn off the switch
and remove the battery. (Fig. 7)
CAUTION: Be absolutely sure to keep the switch
(2) After you have pushed the lever in the direction
of the arrow mark shown in Fig. 8, turn the blade
so it faces downward. The blade should fall out
by itself. If the blade doesn't fall out, pull it out
by hand.
CAUTION: Never touch the saw blade immediately
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains
inside the small slit of the plunger, it should fall out
if you push the lever in the direction of the arrow
mark, and face the blade downward. If it doesn't fall
out itself, take it out using the procedures explained
below.
20
absolutely sure to pull it from the
back. Pulling other parts of the blade
will result in an injury.
turned off and the battery removed
to prevent any accident.
after use. The metal is hot and can easily
burn your skin.
Lever
Fig. 8
Blade
Slit of plunger
Fig. 9
Blade
Slit of plunger
Fig. 10
Lever
Fig. 11
Blade
Lever
Fig. 12