Appliance Door; Removing And Installing The Door Panels; Removing And Fitting The Appliance Door - Bosch HSB738257M Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

qAppliance door
With good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the

appliance door.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using the
2.
locking pin.
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Lift the bottom of the inner panel slightly until the
3.
fastening pins come out of the holder (1).
Carefully lift the top of the inner panel until the
4.
fastening pins come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may
stick to the inner panel. Ensure that the middle panel
does not fall.
Remove the inner panel.
5.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting the door panels
Reinsert the inner panel.
1.
All four fastening pins must engage in the
Note:
holders provided for them.
Remove the locking pins and close the oven door.
2.

Removing and fitting the appliance door

If the oven is very heavily soiled, the oven door can be
removed for easier cleaning. Normally, however, this is
not necessary.
Removing the appliance door
Open the oven door fully.
1.
Lock both hinges on the left and right using the
2.
locking pin (a).
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Grip the oven door on either side with both hands
3.
and close the oven door by approx. 30° (b).
Raise the oven door slightly and pull it out.
4.
Do not fully close the oven door. The hinges
Note:
could become bent and the enamel could be
damaged.
Fitting the appliance door
Grip the oven door on either side with both hands.
1.
Slide the hinges into the slots in the oven (a).
2.
The notch below the hinges must engage into
Note:
the frame of the oven (b).
Lower the door downwards.
3.
Remove the locking pins.
4.
Appliance door
en
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières