Black & Decker Flex Vac BDH2020FLAAPB Mode D'emploi page 9

To Replace the Dust Container
1. Slide the container back onto the base and rotate
the handle toward the front of the appliance until an
audible click is heard. Ensure that the container is fully
fastened back onto the base.
2. Close the container door and make sure it clicks
into place.
Battery Removal and Disposal
This product uses Lithium Ion rechargeable and recyclable
batteries. When the batteries no longer hold a charge,
they should be removed from the vacuum and recycled.
They must not be incinerated or composted. The batteries
can be taken for disposal to a BLACK+DECKER, Company-
Owned or Authorized Service Center. Some local retailers
are also participating in a national recycling program (see
"RBRC® Seal"). Call your local retailer for details. If you bring
the batteries to a BLACK+DECKER Company-Owned or
Authorized Service Center, the Center will arrange to recycle
old batteries. Or, contact your local municipality for proper
disposal instructions in your city/town.
To Remove the Battery Pack for Disposal
(Fig. A, N)
1. Before attempting to disassemble the product, turn it
on and leave it on until the motor completely stops,
ensuring a complete discharge of the battery.
2. Remove the removable bowl
Cleaning the Dust Container section.
3. Invert the appliance to gain access to the screws that
attach the base.
4. Remove the two screws
off the battery housing
5. Detach all lead connections from the battery pack.
6. Remove battery pack and place in suitable packaging to
prevent a short circuit of the battery terminals.
7. Recycle of batteries as per recommended guidelines.
Fig. N
10 as described in the
22 shown in Figure N and lift
7 .
22
TROUBLESHOOTING
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
• The charger cord is not damaged and is
correctly attached.
• The charger is plugged into a working electrical outlet.
• The appliance was switched to the OFF position to
charge. The battery will not be charged with the switch
in the ON position.
• One of the filters may be clogged. Pull the door latch
and open the dust container door. Remove the pre-filter
and the pleated filter. Brush any loose dust off the filters
and wash them in warm, soapy water. Make sure the
filters are dry before placing back in the vacuum.
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service
center nearest you or call the BLACK+DECKER help line at
1–800–544–6986.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
•
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.BLACK+DECKER.com/register.
Accessories

WARNING: Since accessories, other than those
offered by BLACK+DECKER have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BLACK+DECKER, call
1-800-544-6986.
SERVICE INFORMATION
All BLACK+DECKER Service Centers are staffed with trained
personnel to provide customers with efficient and reliable
power tool service. Whether you need technical advice,
repair, or genuine factory replacement parts, contact the
BLACK+DECKER location nearest you. To find your local
service location, call: 1-800-544-6986 or visit
www.blackanddecker.com
English
7