Epson TM-T88III Manuel D'utilisation page 7

To remove the connector cover, turn the printer over, insert a
flathead screwdriver under one hook, and pry up the hook while
lifting the connector cover. See the illustration on the right below.
Repeat this step for the other side.
Note:
Be careful not to damage the cables with the screwdriver.
Installing the Paper Roll
1. Press the button, as shown on the left below, to open the cover.
2. Remove any used paper roll core, and insert the paper roll as
shown in the center below.
3. The correct direction of the paper is shown on the right below.
4. Pull out some paper, as shown on the left below, close the
cover, and tear off the paper, as shown on the right below.
hook
screwdriver
bottom of
the printer
TM-T88III User's Manual 5
English