Intended Use; Symbols On The Unit - Pontec PondoSolar Charge Notice D'emploi

Intended use

PondoSolar Charge, referred to in the following as "unit", may only be used as
specified in the following:
• Only intended for charging the rechargeable battery of PondoSolar 250 Control
or PondoSolar 600 Control.
The following restrictions apply to the unit:
• Only use indoors, never outdoors.
• Install at a dust-free location, protect from direct sunlight.
• Install at a location that is sufficiently cooled and suitably vented.
Connection
How to proceed:
 A
Remove the blind plug from PondoSolar 250 Control or PondoSolar 600 Control.
Insert the charger plug into the socket.
Connect the charger to the power supply socket.
– The LED on the charger is lit red: The rechargeable battery is being charged.
– The LED on the charger is lit green: The rechargeable battery is charged.
N O T E
After charging, insert the blind plug into the socket as far as it goes to close the
PondoSolar 250 Control or PondoSolar 600 Control so that it is watertight.

Symbols on the unit

Protection class II, reliable electrical isolation from the mains by
reinforced or double insulation.
For use indoors.
Do not dispose of with household waste.
Read and adhere to the instructions for use.
- EN -
9