Focal Professional TRIO11 BE Manuel D'utilisation page 25

TRIO11 BE
U s e r m a n u a l
8 - ON/OFF
The ON/OFF switch turns the internal amplifiers on or off.
9 - VOLTAGE SELECTION
This slide switch allows you to select the voltage according to the mains power supply depending on the
country you're in. There are two options: 115V or 230V. To change the voltage, proceed as follows:
1. Turn off the monitor and unplug the power cable
2. Using a flat-head screwdriver, remove the fuse situated below the power socket (11).
3. Replace the fuse with one having the appropriate values:
a. 115V: class T fuse, value 3.15A
b. 230V: class T fuse, value 1.6A
4. Using a Phillips screwdriver, slightly loosen the screws (12), and remove the protection cover from the
voltage selector.
5. Switch the voltage selector (9) to the appropriate setting using a flat-head screwdriver.
6. Using a Phillips screwdriver, put the protection cover for the voltage selector back into place and slightly tighten
the screws (12).
7. Reconnect the power cable (10).
8. Turn on the power to the monitor using the Power ON/OFF switch (8).
10 - POWER SOCKET
Connect the power supply cable supplied to this connector socket.
11 – FUSE HOUSING
This is where the fuse is located to protect the monitor. If necessary, replace the fuse as explained in section
9 - VOLTAGE SELECTION.
12 - SCREWS
Two screws protect access to the voltage selector (9).
13 – POWER LED (front panel)
There are three possible states for the POWER LED:
- Off: no power/monitor off
- Green: monitor on
- Red: the limiter is activated
™
INPUT
EQ'S
FOCUS
> Trio11 Be
FOCUS mode
diagram.
25