Table des Matières
Publicité
INTRODUCTION
Unpacking and Inspection
Your shipping carton should include the digital clamp meter, a carrying
case, one test lead set (one black, one red), one 9V battery (installed), and
this manual. If any of the items are damaged or missing, return the
complete package to the place of purchase for an exchange.
D • Lieferumfang
Die Verpackung sollte enthalten: ein digitales Zangenmultimeter, eine
Tragetasche, ein Paar Meßkabel (ein schwarz, ein rot), eine 9V Batterie (im
Gerät) und diese Anleitung. Sollte ein Teil beschädigt sein oder fehlen, kehren
Sie bitte zur Verkaufsstelle zurück für einen Umtausch.
E • Desembalaje e inspección
El embalaje debe contener el multímetro de pinza, un estuche de transporte, un
juego de puntas (una negra y otra roja), una pila de 9 V (instalada) y este
manual. Si falta algún componente u observa daños, devuelva el conjunto al
lugar donde lo adquirió para que se lo cambien.
F • Désemballage
Votre emballage devrait contenir: un multimètre-pince, une sacoche, une paire
de cordons de test (un noir, un rouge), une pile 9V (dans l'appareil) et ce
manuel. Si une pièce manque ou est endommagée, retournez à votre point de
vente pour un échange.
Instrument Familiarization
1) Transformer Jaws: Designed to pick up the current flowing through the
conductor.
2) Jaw Opening Lever: Press lever to open transformer jaws. Release pressure
to close the jaws.
3) Digital Display: 3 3/4 digit LCD (max. reading 3999), with decimal point,
AC/DC, polarity, unit and low battery (
) indicators.
BT
4) Function/Range Selector: Selects the desired function and range. Changing
position turns instrument back on after Auto-OFF.
5) Peak Hold Button: Toggles on and off. Captures the maximum peak value of
a current or voltage surge (motor sturt-up). "PEAK" is shown on LCD.
6) Data Hold Button: Toggles on and off. Holds reading for all functions and
ranges. Always release HOLD before taking a new measurement. "HOLD" is
shown on LCD.
7) DCA ZERO Button: Push this button to zero the display before measuring DC
current.
8) Input Terminals: Always connect black test lead (negative) to black COM
input jack and red test lead to red "VΩ" input jack for voltage, frequency,
resistance, continuity and diode measurements.
– 4 –
Publicité
Table des Matières
