Input Switch - Rockford Fosgate Prime R2-200X2 Mode D'emploi

Crossover Switch
Selectable switch for
Low-Pass (LP) or All Pass
(AP) or High-Pass (HP)
Note: All mono amps are
fixed at LP.
See Pg. 11
Remote Level Control
Remotely control the sub woofer
output level of the amplifier.
(Only available for mono
channels)

Input Switch

Setting the switch to 5,
4 or 2 lets the amp know
how many inputs are being
used. Match this to the
amount of inputs in either
hi-level or low- level.
See Pg. 11
High Level Inputs - Optional Inputs**
This allows you to connect your amplifier
directly to an OEM head unit without the
addition of an LOC (Line Output Convertor).
See Pg. 10
Design Features
C.L.E.A.N. Output
When the RED LED turns ON,
the output of the amplifier is
distorted. The brighter the LED the
more the signal is clipped.
See Pg. 11
C.L.E.A.N. Input
When the RED LED turns ON, a
distorted signal is being applied
to the input of the amplifier. The
brighter the LED the more the
signal is clipped.
See Pg. 11
Gain Control
The gain control is used to
match the signal level of the
audio source to the input of the
amplifier.
See Pg. 11
Low Level/ RCA Input/ Pass-
Thru Jacks**
The balanced differential
RCA Inputs/Pass-Thru Jacks
are nickel-plated to resist the
signal degradation caused by
corrosion. The Pass-Thru(not
shown) provides a convenient
source for daisy-chaining an
additional amplifier without
illus.-2.2
running an extra set of RCA
cables from the front of the
vehicle to the rear amplifier
location.
Note: Pass-Thru not available
on R2-750X5.
** Use either High or Low
Level input, never both.
7