Beko WMP 10744 XA Manuel D'utilisation page 29

Problem
Washing takes longer than
specified in the user manual.(*)
Programme time does not
countdown. (On models with
display) (*)
Programme time does not
countdown. (*)
Product does not switch to
spinning step. (*)
Washing performance is poor:
Laundry turns gray. (**)
Washing Machine / User's Manual
Cause
Water pressure is low.
Voltage is low.
Input temperature of water is low.
Number of rinses and/or amount of rinse water have
increased.
Excessive foam has occurred and automatic foam
absorption system has been activated due to too
much detergent usage.
Timer may stop during water intake.
Timer may stop during heating step.
Timer may stop during spinning step.
There is unbalanced load in the product.
There is unbalanced load in the product.
The product will not spin if water is not drained
completely.
Excessive foam has occurred and automatic foam
absorption system has been activated due to too
much detergent usage.
Insufficient amount of detergent has been used over a
long period of time.
Washing has been made at low temperatures for a
long time.
Insufficient amount of detergent is used with hard
water.
Excessive amount of detergent is used.
Solution
• Product waits until taking in adequate amount
of water to prevent poor washing quality due to
the decreased amount of water. Therefore, the
washing time extends.
• Washing time is prolonged to avoid poor washing
results when the supply voltage is low.
• Required time to heat up the water extends
in cold seasons. Also, washing time can be
lengthened to avoid poor washing results.
• Product increases the amount of rinse water
when good rinsing is needed and adds an extra
rinsing step if necessary.
• Use recommended amount of detergent.
• Timer indicator will not countdown until the
product takes in adequate amount of water. The
product will wait until there is sufficient amount
of water to avoid poor washing results due to lack
of water. Timer indicator will resume countdown
after this.
• Timer indicator will not countdown until the
product reaches the selected temperature.
• Automatic unbalanced load detection system is
activated due to the unbalanced distribution of the
laundry in the product.
• Automatic unbalanced load detection system is
activated due to the unbalanced distribution of the
laundry in the product.
• Automatic unbalanced load detection system is
activated due to the unbalanced distribution of the
laundry in the product.
• Check the filter and the draining hose.
• Use recommended amount of detergent.
• Use the recommended amount of detergent
appropriate for water hardness and the laundry.
• Select the proper temperature for the laundry to
be washed.
• Using insufficient amount of detergent with hard
water causes the soil to stick on the cloth and
this turns the cloth into gray in time. It is difficult
to eliminate graying once it happens. Use the
recommended amount of detergent appropriate
for water hardness and the laundry.
• Use the recommended amount of detergent
appropriate for water hardness and the laundry.
29 / EN