Adjusting The Feet; Electrical Connection; Initial Use - Beko WMP 10744 XA Manuel D'utilisation

• To prevent the waste water to go back into the product again and to ensure easy drainage, do not immerse
the end of the hose into the waste water or do not insert it into the drain for more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched
between the drain and the product.
• If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may
not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the
drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.

4.1.6 Adjusting the feet

A
WARNING:
balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause
crushing, noise and vibration problems.
WARNING:
1 Loosen the lock nuts on the feet by hand.
2 Adjust the feet until the product stands level and balanced.
3 Tighten all lock nuts again by hand.

4.1.7 Electrical connection

Connect the product to a grounded outlet protected by a 16 A fuse. Our company shall not be liable for any
damages that may arise when the product is used without grounding in accordance with the local regulations.
• Connection must comply with national regulations.
• The electrical connection cable infrastructure of the product must be adequate and suitable for product
requirements. It is recommended to use a residual current device.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
• The voltage specified in the "4. Technical specifications" section must be equal to your mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
WARNING:

4.1.8 Initial use

C
Use an anti-limescale suitable for the washing machines.
Some water has remained in the product due to the quality control processes in the production. It is not harmful for the
product.
10 / EN
In order to ensure that the product operates more silently and vibration-free, it must stand level and
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
Damaged power cables must be replaced by the Authorised Service Agent.
Before starting to use the product make sure that the preparations
described in section "2. Environmental instructions" and "4.1 Installation".
To prepare the product for washing laundry, perform first operation
in Drum Cleaning programme. If this program is not available in your
product, apply the method which is described in section "4.4.2 Cleaning
the loading door and the drum".
Washing Machine / User's Manual