Disposal - Zipper Maschinen ZI-RMM95 Mode D'emploi

Disposal

18 TROUBLESHOOTING
Danger from electric voltage and compressed air! Manipulation of the machine
with the power supply or compressed air supply upright can lead to serious injuries or
death. Always disconnect the machine from the power supply and compressed air
supply before carrying out any troubleshooting work.
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct/solve the problem!
Failure
Tyre disc turns in one direction
only
Tyre disc does not rotate at all
Tyre disc stalls during rotation
Clamping jaws open/close too
slowly
Jaws do not clamp rim sufficiently
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RMM95
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
W A R N I N G
Problem: commutator broken
solution: let commutator be replaced
Problem: defect belt
Solution: replace belt
Problem: belt not tensioned
Solution: tension the belt
Problem: commutator broken
solution: let commutator be replaced
Problem: motor defect
Lösung: let this possibity be checked by a certified electrician who
should check the power supply, the cables and the motor to localize
the error exactly.
Problem: belt slips
Solution: clean + tension belt
Problem: pressure air silencer in the machine
Solution: Through belt access door you gain access to silencers as well,
clean them!
Release pressure from hydraulic system beforehand!
Problem: insufficient compression rate supply
Solution: check compression air supply pressure
Problem: jaws defect
Solution: replace jaws
Problem: pressure air silencer in the machine
Solution: Through belt access door you gain access to silencers as well,
clean them!
Release pressure from hydraulic system beforehand!
Problem: clamping cylinder defect
Solution: replace cylinders
Possible cause / solution
TROUBLESHOOTING
26