Mount Tyre Onto A Rim; Inflate Tyres - Zipper Maschinen ZI-RMM95 Mode D'emploi

 Keep hands/feet of danger area of bead-breaker!
 Operate foot pedal (1), the bead-breaker will press the tyre off the rim.
 Remove these steps several times until the tyre is separated from the rim entirely.
 Place the tyre onto the tyre disc (5). ATTENTION: for asymmetric lowbed-rims place the rims
so that the flat side shows upwards.
 Operate foot pedal (2) for clamping and centering the rim.
 Attention: For sensible rims use the four provided plastic clamps.
 If you wish to clamp your rim from inside to outside, first operate pedal (2) until jaws are
centered in the middle, place the rim onto the tyre disc and operate the pedal (2) again.
 Swing the swing arm (9) into working position over the rim edge, press the mounting bar
downwards until the mounting head (7) clears the rim edge 1-2mm
 Fix the head in this position with the height fixation lever (11) and fix the swing arm position
as well.
See figure D:
 Slip the outer tyre bead with the help of the provided mounting bar over the mounting head (7).
 Operate the foot pedal (3) to move the tyre disc (5) until the outer tyre bead is slipped over
the rim edge entirely. Always check the postion of the valve during rotation to avoid damage!
See figure E:
 Remove the air tube first, if present.
 Slip with the mounting lever the lower tyre bead over the mounting head.
 Operate the foot lever (3) to pull the entire lower tyre bead over the rim edge

Mount tyre onto a rim

 Check whether tyre and rim match regarding technical dimensions, especially width and
diameter!
 If using a new rim, clamp it as described, if you mount a new tyre on a already clamped rim –
let it be clamped.
 Lubricate the tyre bead with suitable lubricant!
See Figure F:
 Place the tyre onto the rim in a way, that the left side is higher than the right side and bring
the mounting head into position as shown in the figure.
 Position the tyre in a way that the tyre bead is over the left (see Fig. F 1) but is simultaneously
under the right side (see Fig. F 2) of the mounting head.
 Operate foot pedal (1), the inner tyre bead gets pulled under the rim edge.
 If required, insert now the tyre-tube in a way that it will not constrain the mounting.
See Figure G:
Perform the mounting similarily.
But when having the last 10-15cm being pulled under the rim edge take special care that the tyre
bead gets not damaged. Stop the tyre disc if required and reverse if necessary. Try to easy the pull
down by pressing onto the tyre on the other side already being pulled under the rim.

Inflate tyres

Always check whether tyre and rim match together in all technical aspects.
Check extensively, whether there is any damage or anormality of the tyre or rim and
check whether the tyre is really mounted onto the rim correctly.
NEVER exceed the max. tyre pressure recommended by the tyre manufacturer.
When inflating air into the tyre, check the pressure frequently, check regularily the
tyre shape.
During the air inflating process itself keep yourself away from the tyre as much as
possible.
In order to inflate a tyre connect the provided inflating device to the air hose (14).
Connect the inflating device to the tyre valve. Through pressing the lever of the inflating device air
gets inflated into the tyre.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RMM95
W A R N I N G
OPERATION
24