Krüger & Matz KM0544 Mode D'emploi page 21

Owner's manual
B - HORIZONTALLY
User can stick rubber feet to the soundbar:
1. Ensure the surface is clean prior to sticking the rubber foot to the bottom of
the unit.
2. Remove the backing paper from the rubber foot.
3. Stick the rubber foot to the bottom of the unit as shown in the illustration
below.
Rubber feet
C - WALL MOUNTING
Note: Wall mounting must be carried out by qualified personnel only. Incorrect
assembly may result in severe personal injury and property damage. The supplied
wall brackets are only for use on vertical walls suitable for such mounting. It is the
installer's responsibility to verify that the wall will safely support the total load of the
Soundbar and wall brackets. Additional tools required for the installation are not
included. Do not overtighten screws.
1. Drill 4 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The
distance between the holes should be 764 mm.
2. Firmly fix 1 dowel into each hole in the wall if necessary.
3. Tighten the wall mount brackets on the wall with screws and screwdriver (not
included). Make sure the they are securely installed.
4. Loosen the screws at the back of the unit for 3 mm. Lift the unit onto the wall
mount brackets and slot into place.
Rubber feet
21