Amana AGR6603SFS Instructions D'installation page 16

4. Remove 2 screws from the front tabs of the flame spreader.
Lift front of the flame spreader and pull forward to remove
tabs from rear of oven and set it aside on a covered surface.
B
A. Screws
B. Flame spreader
5. Remove 2 screws from the bake burner.
6. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside.
A. Screws
B. Bake burner
7. Use a / "(1 cm) nut driver or combination wrench and turn
3
8
the Natural gas bake burner orifice spud counterclockwise to
remove. The spud will be stamped with a "49."
8. Replace the "49" spud with a "57" spud. Install the Propane
gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
9. Position the back of the bake burner over the oven orifice,
and slide the tab on front of the bake burner into the front of
the oven
10. Reattach the bake burner with 2 screws.
16
A
B
A
A
A. Orifice spud
11. Insert the tabs on the rear of the flame spreader into the rear
of the oven.
12. Reattach the front tabs of the flame spreader to the oven
with 2 screws.
13. Position the front of the oven bottom panel toward the front
frame and lower the rear of the oven bottom panel into the
oven.
14. Reattach the oven bottom panel with 2 screws.
To Convert Oven Broil Burner (Natural Gas to
Propane Gas)
1. Remove the screw from the broil burner
2. Remove the broil burner from the broil burner orifice hood.
NOTE: The broil burner will hang in the back of the oven
while changing the orifice hood.
B
A. Broil burner
B. Screws
C. Orifice hood
3. Use a ³⁄ " (1 cm) combination wrench and turn the Natural
8
gas broil burner orifice hood counterclockwise to remove.
The hood will be stamped with a "53."
4. Replace the "53" hood with a "090" hood. Install the
Propane gas broiler burner orifice hood, turning it clockwise
until snug.
IMPORTANT: Do not overtighten.
5. Place the broil burner on the broil burner orifice hood and
insert the broil burner ceramic igniter in the hole in the rear of
the oven.
6. Position the broil burner against the top of the oven and
attach it with 2 screws.
7. Replace storage drawer, warming drawer or premium
storage drawer. See the "Storage Drawer" or "Warming
Drawer or Premium Storage Drawer" section.
8. Replace the oven door if it has been removed. See the "Oven
Door" section.
9. Replace the oven racks.
A
C
A
A. Orifice hood