Yamaha YTS-V1100 Manuel D'installation page 9

■When using only the TV mounting bracket
4. Taking care not to damage the TV, spread a soft
cloth on a level surface and carefully lower the TV
screen down onto it. Then remove the table-top
stand from the TV.
To remove the stand, unscrew the
screws that fasten it to the TV.
Blanket or
other soft cloth
The method used for removing the table-top stand, the location and
Caution
number of screws and method of handling the TV will vary depending
on the TV model. Be sure to refer to the TV' s user' s manual.
If you anticipate using the table-top stand again, you will
Caution
need the table-top stand mounting screws, so store them
carefully with the table-top stand so they are not lost.
5. Wire all cabling to the TV and remove the four
screws for wall-mounting the TV from its rear.
(Refer to the TV' s user' s manual for information on
connecting cables to your TV.)
Screws for
wall mounting
The location of screws that need to be removed from the
Caution
back will vary with the model of TV. Be sure to refer to
the TV' s user' s manual.
6. Temporarily screw the two TV mounting screws
halfway in at the top of the TV.
Temporarily
screw in
Check the size of the TV mounting screws in your user' s
Caution
manual under the section for mounting your TV on a wall.
If this information is not listed, find the appropriate screw by
mating the TV mounting bracket to your TV and gently trying
the screws in order from the shortest and smallest screws up
to longer and larger screws. While doing so, if it feels like the
tip of the screw has run into something, immediately stop
screwing the screw in any further.
*If you will use the mounting adaptor, proceed to page 7.
7. Mount your TV on the rack.
(1) Mount the TV by hanging the TV mounting screws you
temporarily screwed in on the mounting holes in the TV
mounting bracket.
Table-top stand
mounting screws
Table
Table-top stand
(2) Using the two TV mounting screws, line up the lower
holes on the back of your TV and the bottom holes on the
TV mounting bracket, making sure the TV is centered and
level, and then tighten the two TV
Screws for mounting screws.
wall mounting
(3) Tighten the screws that were temporarily screwed in
halfway in step (1).
Caution
The size of the screws
for mounting the TV
may vary with the
model, so check the
size before installation.
Screw sizes
(F) M5 x 16
(G) M6 x 14
(H) M6 x 20
(I) M8 x 20
5 En
Installation of your TV
This product is heavy.
When moving it, two or
more people should carry it.
TV
Hole
When mounting your T V, take your time as you
carefully attach it to the stand. If you drop it onto the
Caution
bracket, it may bend the bracket and/or put the screw
holes out of alignment.
If the holes do not line up left-right, or if the TV is not
Caution
level, move the left or right side of the TV a bit to find
the right position.
After tightening the screws for mounting the TV, check
Warning
and make sure that all of them are fully tightened.
Failure to tighten them properly may cause the TV to
tip over or break, resulting in injury.
TV mounting
bracket