Yamaha YTS-V1100 Manuel D'installation page 12

■When using the TV mounting bracket + mounting adaptor
13. Temporarily screw the two mounting adaptor
screws halfway in the top holes of the mounting
adaptor.
14. Mount your TV on the rack.
(1) Mount the TV by hanging the mounting adaptor screws you temporarily screwed into the mounting
adaptor on the mounting holes in the TV mounting bracket.
Installation of your TV
This product is heavy.
When moving it, two or
more people should
carry it.
TV
When mounting your TV, take your time as you carefully
Caution
attach it to the stand. If you drop it onto the bracket, it may
bend the bracket and/or put the screw holes out of alignment.
(2) Using the two mounting adaptor screws, line up the
lower holes on the back of the mounting adaptor and the
bottom holes on the TV mounting bracket, making sure
the TV is centered and level,
and then tighten the screws.
If the holes do not line up left-right, or if the TV
Caution
is not level, move the left or right side of the TV
a bit to find the right position.
Mounting adaptor
Hole
TV mounting bracket
8 En
Temporarily
screw in
■Positioning of TV mounting bracket screws to tighten
500 (W) x 200 (H)
500
300 300
300 200
300
(3) Tighten the screws that were temporarily screwed in
halfway in step (1).
After tightening the screws for mounting the TV,
Warning
check and make sure that all of them are fully
tightened.
Failure to tighten them properly may cause the
TV to tip over or break, resulting in injury.
400 200
400 300
400 400
400
200 200
200