Yamaha YTS-V1100 Manuel D'installation page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
■When using only the TV mounting bracket
8. Connect the wiring for the TV, speaker rack and any other equipment.
(Refer to the user' s manuals for information on connecting wiring for each device.)
9. After everything has been installed, remove the auxiliary support and rest the rack against the wall in its appointed
location. After removing the auxiliary support, store it with its three auxiliary support mounting screws E (M5 x 12) in a
safe place. In addition, to prevent an accident with this rack, be sure to screw the wires accompanying this product to
the wall, thus preventing it from tipping over. (Refer to the user' s manual for the rack as well.)
*When placing the rack against
the wall, make sure that no power
cords or cables get sandwiched
in between.
Be careful when setting the unit against the wall that no
Caution
cables are sandwiched between the wall and the rack.
Install this rack in a sturdy location. In addition, be
Warning
sure to install it against a wall and take measures
to prevent it from tipping over. If no measures are
taken to prevent it from tipping over, the rack may
tip over, causing injury and/or damage.
*If you will use the mounting adaptor, proceed to page 7.
Ferrite core
Tie base
Plastic tie
Attach the tie base that comes
with this product to the inside of
the support column and use the
plastic tie to secure the wiring
for your TV so it does not hang
down.
Securing the Unit so it does not Tip Over
1. Use the screw holes on the back of the TV mounting
bracket to hold the supplied wires.
(The installation position may vary with the model of TV
and/or the height. Install the wires to suit the TV.)
2. Use commercially available screws to fasten the wires
securely to a wall or stud that can support the TV.
Wall
(Select screws that are appropriate for the type of wall.)
TV mounting
bracket
6 En
Caution
Wire the power cord so the ferrite core does
not end up behind the support column.
It may be damaged if it is sandwiched in
between the wall and the support column
when the rack is set against the wall.
Caution
The methods for connecting your TV and/or
other equipment may differ, so be sure to
refer to the user' s manuals for TV and
each device.
Wire
Screw
Wire
TV mounting
TV mounting
bracket screws
bracket screws

Publicité

Chapitres

Table des Matières
loading

Table des Matières