Connection; Connection Of The Cinch Outputs And The Remote Control Line - Renkforce CD-1000 Mode D'emploi

8. Connection

Before connecting the device, ensure that the mains plug is disconnected. Also disconnect all
other devices to be connected from their power supply.
Observe connection of the audio connections in the correct direction, i.e. always connect left to
left and right to right.
a) Connection of the Cinch Outputs and the Remote Control Line
For the connection of the cinch sockets only use the shielded cinch wires. Use of any other
cables may cause interferences.
To avoid distortions or mal-adjustments that may cause damage to the device, only such de-
vices must be connected to the cinch sockets that also have cinch connections.
Use only the enclosed remote control line to connect the remote control connections.
• Connect the outputs OUTPUT to the CD input of your amplifier
Connect the white cinch socket to the left cinch connection of the amplifier.
Connect the red cinch socket to the right cinch connection of the amplifier.
• If you use the Renkforce amplifier A-1000, connect the remote control input REMOTE SYSTEM TO AMP
to the corresponding control socket REMOTE SYSTEM CD at the amplifier. You can then remote-control
the CD player with the system remote control.
R E M O T E SYSTEM
T O A M P
OU T P U T
RE M O T E S Y ST E M
GN D
E Q TA P E TU NE R CD
TA P E
P H O N O C D AV 1 AV 2 T U N E R P L A Y
L
R
A U D I O
CD
IN T E G R AT E D C IR C U IT
PO W E R CO N S U M PT I O N
RI G H T L E F T
L
E Q
R E C P L A Y R E C
L
_
R
S P E A K E R S 6 ~ 8
C D P L AY E R
A C 2 20 V ~ 50 H z
1 0W
IN T E G R A T ED C IR C U I T
A C 2 20V - 23 0V ~ 50H z
_
23