Brandt ULN2510 Guide D'installation Et D'utilisation page 32

Reversing the direction the door opens
EN
Drawing R5
Adjusting the hinge
Sometimes the top door and the strip are not
perfectly aligned (Drawing R5). In this case, unscrew
A
the fixing screw slightly from the cover (A) over the
top hinge. Then screw it in again and check that the
seal is perfectly hermetic.
Drawing R6
Reversibility of the handle
Unscrew the handle from the left-hand side and
refit it on the right-hand side (Drawing R6). Use
the handle to determine the position of the new
holes (2.5mm diameter) for fixing the handle.
If the doors already have holes on both sides:
Remove the plugs covering the handle's screws
and those on the opposite side covering the
holes. Unscrew the handle and place it on the
other side (see Drawing R6). Screw the handle on
and insert the plugs covering the screws and the
holes.
32