Exchanging Preset Stations - Yamaha RX-496RDS Mode D'emploi

When the automatic preset tuning is finished;
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 18.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on page 18.
*
RX-496RDS, RX-396RDS
A recalled station is shown by the frequency or station name
on the display.
*
RX-496, RX-396
A recalled station is shown by the frequency on the display.
Notes
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on page 18.
RX-496RDS and RX-396RDS only
The automatic preset tuning search will be performed
through all RDS network frequencies until stations are stored
up to E8. If the number of received stations is not enough to
be stored up to E8, the search is finished automatically after
searching all frequencies.
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 18.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.
RX-496 and RX-396 only
If the number of received stations is not enough to be stored
up to E8, the search is finished automatically after searching
all frequencies.
With this function, only FM stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 18.
20

EXCHANGING PRESET STATIONS

You can exchange the places of two preset stations with each
other as shown below.
NATURAL SOUND STEREO RECEIVER
STANDBY/ON
A/B/C/D/E 1 2 3 4
BASS TREBLE BALANCE
PHONES SPEAKERS
0 0 0
l l l l l l
A B
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
ON OFF
5 5 5 5 L 5 5
Example)
If you want to shift the preset station on E1 to A5, and vice
versa.
1
Recall the preset station on E1 (by following the method
of "To recall a preset station" on page 18).
2
EDIT
3
Recall the preset station on A5 by following the same
method as in step 1.
4
EDIT
TUNER PHONO CD
28
40
TAPE 2 60
AUX TAPE 1/MD
MONITOR
5 6 7 8
LOUDNESS
FM/AM DOWN TUNING UP
FLAT
l –30dB
2 2 l0
TUNING
3 3 9 MEMORY EDIT MODE
4 4 8
R 5 7
6 MAN'L/AUTO FM AUTO/MAN'L MONO
2, 4
Flashes.
MEMO
Flashes.
MEMO
Shows the exchange of
stations is completed.
VOLUME
l6
20
l2
8
4
2
0
–dB