Connections - Yamaha RX-496RDS Mode D'emploi

Never plug in this unit and other components until all connections are completed.
CONNECTIONS WITH OTHER COMPONENTS
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left)
to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.
* If you have YAMAHA components numbered as 1, 3, 4, etc. on the rear panel, connections can be made easily by making sure
to connect the output (or input) terminals of each component to the same-numbered terminals of this unit.
Turntable
*
75Ω
UNBAL.
FM
ANT
GND
GND
AM
ANT
PHONO CD AUX
1
CD player
1 2
* *
: See page 7.
,
6

CONNECTIONS

Tape deck,
MD recorder, etc.
2
REMOTE CONTROL
IN OUT
TAPE 1 TAPE 2
PLAY /MD REC PLAY REC
or or
3 4 3 5 4 6
AUDIO SIGNAL
Video cassette player,
LD player, etc.
Speakers A
Right
A OR B:4ΩMIN. /SPEAKER
A B:8ΩMIN. /SPEAKER
A OR B :6ΩMIN. /SPEAKER
A B: I2ΩMIN. /SPEAKER
IMPEDANCE SELECTOR
SET BEFORE POWER ON
A
B
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
SPEAKERS
Tape deck,
MD recorder, etc.
Left
(U.S.A. model)
1
*
I20V 60Hz
I00W MAX. TOTAL
SWITCHED
AC OUTLETS
Right
Speakers B
To AC outlet
Left