Training - IKRA IAF 40-3325 Manuel D'utilisation

7. Do not permit any person under the age of
16 to use this machine (the minimum age for
usage can be regulated differently in different
areas).
8. Keep persons, in particular children and pets
away from the machine.
9. Never operate the machine indoors but al-
ways only in the open. Overbuilt and high-
walled paths may only be cleared when safe
operation is possible. Pay particular attention
to windows and persons in the proximity in
order to exclude injury to persons and dam-
age to property.
10. Never direct the machine towards persons.
11. Do not use the snowplough near glass, motor
vehicles, windows etc. without correctly ad-
justing the angle of the snow ejector.
12. For the work or for maintenance always wear
gloves, safety glasses, tight-fitting winter
clothes and strong shoes with profiled soles.
13. Never allow body parts or clothing near rotat-
ing machine parts.
14. Use the machine only where there is suffi-
cient light. Always hold the machine and the
handles tightly. Never run with the machine.
15. Use the machine only for light, loose snow
(new snow) up to a maximum depth of about
25 cm.
16. Frozen snow and ice must not be cleared
with this machine.
17. Allow the motor to cool down before storing
in an enclosed room.
18. Operate the machine only in faultless condi-
tion as established by the manufacturer and
delivered.
19. Use only original spare parts from the manu-
facturer or parts from a different supplier but
approved by the manufacturer.
20. Allow the machine to be repaired only at a
qualified workshop.
21. Do not make adjustments while the machine
is running (unless the adjustments are rec-
ommended directly by the manufacturer).
22. The safety gap to the rotating parts defined
by the guide bar must always be assured.
23. Stop the motor before moving it over surfaces
such as pavements or yard entrances which
should not be cleared. Operate the machine
always only in a faultless and safe condition.
24. Check the area to be cleared and remove all
objects which could be taken up and ejected
by the machine.
GB | Operating Instruction
25. Possible damage to the machine: When for-
26. Operate the machine only in faultless con-
27. In case of extreme temperature differences,
28. Work slowly and carefully, particularly when
29. Clear snow immediately after snowfall; later
30. Where possible clear in the wind direction.
31. Clear snow so that the cleared tracks overlap
32. This appliance is not intended for use by per-
33. Children should be supervised to ensure that
34. Switch the motor off and remove the rechar-

Training

1. Read the operating and service instruction
GB-4
eign bodies (e.g. stones) strike the machine
or unusual vibration occurs, switch off the
machine and check for damage. Repair any
damage before working any more with the
machine.
dition. Make a visual inspection each time
before starting up. Inspect for damage in
particular the safety components, electri-
cal operating elements, electrical wiring and
screw connectors for tightness. If necessary
replace damaged parts before operating.
please allow the rotary snowplough a short
time to adjust to the ambient temperature
before beginning to clear snow. Otherwise,
by beginning immediately with the work,
early wear on the drive shaft and other com-
ponents, for example rubber seals can take
place.
changing direction. Direct the machine
against the gradient or with the gradient, but
not across it. Watch out for hindrances, do not
work near hilly terrain. Never use the machine
on slopes with a gradient more than 20%.
the snow layer beneath turns icy and makes
the work difficult.
a little.
sons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
they do not play with the appliance.
geable battery if you
• are not using the machine
• are leaving the machine unattended or
• when carrying out adjustments, mainte-
nance or repair work.
manual carefully. Be thoroughly familiar with
the controls and the proper of the equipment.