Cleaning And Care Of The Unit And Belt; Disposal - Beurer EM 38 Mode D'emploi

Note:
If you change the program during the stimulation (for example from A to B), the initial intensity in the new
program increases incrementally up to the previously set intensity. This can be stopped if necessary by
pressing the ▼ intensity button [2] for two seconds or by switching off the unit by pressing the on/off but-
ton [1] for two seconds.
Stopping impulses that are too strong
You can decrease the intensity at any time or switch off the unit by pressing the on/off button [1] (approx.
2 seconds).
Adjusting the intensity
Press the ▲ intensity button [2] to increase the intensity incrementally or press the ▼ intensity button [2] to lower
the intensity. You can adjust the intensity in 20 Increments. Depending on the intensity level, you feel a prickling
at first that can escalate to a muscle contraction.
Select a setting that is within your comfort level.
Preventing unwanted pulse changes
To prevent an accidental increase in intensity during a treatment session, simply activate the keylock. To do
so, press the program selection button P [3] for approx. 2 seconds. An acoustic signal sounds and the "
symbol appears in the display[5].
To cancel the keylock, press and hold down the P [3] button for approx. 2 seconds.
Reacting to unpleasant sensations
If you feel a stinging or itching sensation, switch off the unit and proceed as follows:
• Check whether the electrodes are working properly or are defective.
• Check whether the round cover is still present over the electrode connections.
• Take off the belt and moisten it completely once again.
• When refitting the belt, ensure good skin contact and good moistening.
Inserting a pause
If you want to take a break or pause a program, press the pause button [1] briefly. An acoustic signal sounds and
the "II" pause symbol flashes in the display [5]. You can resume the program by pressing the button [1] again.
Contact detection
If the electrodes have no contact with the body, the intensity is set automatically to zero. This prevents unwanted
stimulation. The intensity cannot be increased without contact with the body.
Memory function
The unit stores the most recently configured program.
After a battery change, the unit starts with the first program again.

7. Cleaning and care of the unit and belt

Cleaning the unit
• Remove the batteries from the unit before each cleaning.
• Clean the unit with a soft cloth moistened slightly with water after use. If the dirt is heavier, you can also mois-
ten the cloth with a mild soap solution.
• Ensure that no water penetrates the unit. If this should occur, do not use the unit until it is completely dry.
• Do not use any chemical cleaners or abrasives for cleaning.
Important
The belt and control unit are not suitable for machine washing.
Cleaning the belt
Once you have removed the control unit from the belt, you can clean the belt using a soft cloth. To do so, use a
mild soap solution or liquid detergent. Do not use bleaching agents.

8. Disposal

F
or environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance with EC
Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact the local
authorities responsible for waste disposal.
17
"