Automatic Shutoff; Operation - Beurer EM 38 Mode D'emploi

Ensure that the belt fits tightly enough to provide a good contact between the electrodes and your skin, but
does not constrict.
Extending the belt
If the belt is not adequate for your waistline, you can use the extension belt provided. Depending on your
waistline, the holder for the control unit may be away from the centre of your body. It is important that the
belt is positioned correctly, therefore the electrodes C must be to the left and right of the spinal column.
Inserting the control unit
• Insert the control unit into the holder on the belt.
• The operating keys should be facing outwards and the display should be
facing upwards and towards you.
• If inserted correctly, the control unit clicks into the holder.

Automatic shutoff

If the unit is not used after being switched on, it switches off automatically
after 3 minutes.
Changing the batteries
If the battery status indicator [6] flashes, it is time to change the
batteries. To insert or replace batteries,
you have to remove the control unit from the holder of the belt.
• Release the magnetic connection by gently pulling the control unit
away from the belt. You can feel the magnetic connection of the two
contact buttons unsnap.
• Pull the unit upwards and out of the holder.
• Open the battery compartment [4] by pushing the cover downwards
at the arrow mark.
• Insert 3 x 1.5 V batteries, type AAA (LR03 Micro). Ensure the correct polarity.
See the diagram inside the battery compartment.
• Do not use any rechargeable batteries!

6. Operation

General information about use
The back belt is intended for individual treatment of pain in the lower back area.
Do not switch on the unit until the belt is fitted correctly. See item 5.
Switching on the unit
Press and hold down the on/off button [1] until a brief signal sounds and the LCD display [5] switches on.
When the unit is started for the first time, Program A is activated automatically.
Selecting the program
Press the program button P [3] to switch through the programs. The following programs are available:
Program Frequency
A 4 Hz –110 Hz (3 phases)
B 4 Hz
C 2 Hz (burst)
D 100 Hz
Note:
For program A, you can feel the effect become stronger when switching from phase 1 to phase 2 (after ap-
prox. 10 minutes). This is normal and intentional. If the intensity seems too high, decrease it using the
▼ intensity button [2].
Time
30 min.
25 min.
25 min.
25 min.
16