Lucci fini 210012 Guide D'installation page 5

Installation Instructions
NOTE:

Fan installation must be complete including assembly of blades before operating the remote control.

This remote control is only suitable where the controller/receiver can be inserted inside the canopy
cover safely and securely. Ceiling fans with mount bracket type shown in Fig. 4 would be suitable.

The controller wiring circuit must NOT be shared with any electrical equipment that is sensitive to
voltage fluctuation, such as flood lights with infrared sensor.

DO NOT use the wiring of the controller, other than for the purpose of supplying power into the
controller, and connections to the equipment that is under control. Any outside wiring connections
which are not part of the controller/controlled circuit may affect the operation of the controller and will
void warranty.

The ceiling pitch should not exceed the fan hanging system maximum supported pitch. It will damage
the receiver and cause electric shock. Please check with retailer about pitch angle suitable for fan
mounting with remote control.

To avoid damage to the remote, DO NOT use in conjunction with fan wall controls that have speed
adjustment or light dimmer as function:
If the remote control device is to be installed with an existing ceiling fan with any of the above wall fan
controls, replace the fan wall control with the double pole ON/OFF switch shown below:
A double pole wall switch must be included in the wiring installation. The double pole switch allows you to
disconnect the remote control from the mains 240VAC power during maintenance and cleaning of the
ceiling fan.
5 | P a g e