Lucci fini 210012 Guide D'installation page 3

Installation Instructions
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or in the
same room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 1 Remote battery compartment
Installation directions
- For your safety: Power to the circuit must be disconnected or switched off.
- Household power can cause SERIOUS INJURY or DEATH.
Wiring must meet all local and national electrical wiring codes.
-
MAKING THE ELECTRICAL CONNECTIONS (see Fig. 3)
Use the wire nut terminal block provided for making connections.
1. Disconnect electrical power from the working circuit.
2. Remove the ceiling fan CANOPY cover from the mounting bracket.
3. Disconnect existing wiring from the supply at ceiling.
4. Connect the earth (GREEN/YELLOW) wire to the supply EARTH wire, and ensure continuity for the whole
electrical earth wiring.
5. Connect AC IN L of control unit to AC L supply wire.
6. Connect AC IN N of control unit to AC N supply wire.
7. Connect TO MOTOR N of control unit wire to the MOTOR (N) fan wire.
3 | P a g e
WARNING – HIGH VOLTAGE
BEFORE CONNECTING THE RECEIVER & CHANGE CODES
Fig. 2 Receiver DIP switch