ZANKER KBA23001SK Notice D'utilisation page 20

x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance
as shown in figure.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of
right hinge, SX in opposite
case.
20
x
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
C
D
E
Attach the covers (C, D) to
the lugs and the hinge
holes.
Attach the hinge covers
(E) to the hinge.
2
1
4mm
44mm
Adjust the appliance in the
niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
Ha
E
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
Attach the appliance to
the niche with 4 screws.
Hb
~50 mm
Hc Hd
Install the part (Ha) on the
inner side of the kitchen
furniture.
I
I
~50 mm
o
90
21 mm
o
90
21 mm