Replacing The Lamp; Closing The Door - ZANKER KBA23001SK Notice D'utilisation

Problem
Water flows on the ground.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover (refer
to the illustra-
tion).
3. Replace the
used lamp with a
new lamp of the same power and specifically de-
Possible cause
Products prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease
to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
signed for household appliances (the maximum
power is shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Solution
17