Wired Lan - Monster TULPAR T7 V25.1 Manuel De L'utilisateur

• Wired LAN

Using cables and network adapters to connect to the Internet. Before setting up the
connection of Dynamic IP/PPPoE or Broadband (PPPoE) or Static IP, contact your Internet
Service Provider (ISP) or network administrator for assistance of setting up Internet
connection.
• Dynamic IP/PPPoE Connection
1. Open up Settings, find and click [Network & Internet].
2. Select [Ethernet] within the Network & Internet selection menu.
3. Select [Change adapter options] to bring out Network Connections window.
4. Right click on [Ethernet] to select [Properties] from the drop-down menu.
5. Open up Ethernet Properties window, find and select [Internet Protocol Version
4 (TCP/IPv4)] in Networking tab. Then click [Properties] to continue.
6. Click [Obtain an IP address automatically] and [Obtain DNS server address
automatically] in General tab. Then click [OK].
•
Static IP Connection
7. Follow the previous steps 1 to 4 to continue.
8. Click [Use the following IP address] and [Use the following DNS server
addresses] in General tab. Fill the IP address, Subnet mask, Default gateway,
Preferred DNS server, and Alternate DNS server. Then click [OK].
EN
33