Auto Simple Calibration; Recovery Of The Default Values From Memory; Specification Of Output Interface - Gram AHV Série Manuel D'utilisation

Auto simple calibration

key for about 3 seconds and the display will show a "calibration
Press
weight value".
Put the weight exactly the same with the display value on the pan. When the
"CAL" flashing at the lower right disappears, the Calibration procedure is
finished.

Recovery of the default values from memory

In normal weighing mode, hold down the
balance will be recovered with a default calibration values.

SPECIfICATION Of OUTPUT INTERfACE

Mode: EIA-RS-232 C's UART signal, or USB signal
format:
baud rate:
Data bits:
Parity bit:
Stop bit:
Code:
RS232 connector is a 9-pin D-subminiature socket.
1200-9600 BPS
8 bits/ 7 bits
none/Even
1 bit
ACSII
key for 3 seconds. Then the
F
25