Parameters Set-Up - Gram AHV Série Manuel D'utilisation

Press
Put the sample considered to be 100% on the pan, and then press the
to perform sampling process. Then the "Mode" symbol starts flashing and
several seconds later, the "Mode" symbol and "P" disappears.
Then the sampling procedure is finished. Take away the sample and put
other objects on, the display will show a percentage (the objects' weight to
the 100% sample weight).
• The sample weight considered to be 100% should be larger than 0.2d,
or the display will show "- -or- -%", which indicates that larger sample
weight should be put on.
Note:
1. Press the
percentage weighing) is finished, it will return to normal weighing mode.
Then press the
percentage weighing mode again; and the sampling data can also be used.
2. The sampling data will be cleared automatically when after switching
between counting mode and percentage weighing mode.

PARAMETERS SET-UP

In normal weighing mode, press
mode. The "Setup" message appears.
16
key or key to switch between 100.0% or 100.00%.
key after the sampling procedure (parts counting or
key, the balance will return to parts counting or
key to enter into parameters set-up
F
key