GBC HeatSeal H520 Manuel D'utilisation page 5

Operation, hot lamination
Connect the power cord plug to the appropriate power source.
1
Push the power button to "ON" position, the LCD display will
2
illuminate.
3 Using the lamination guide located on the machine (fig.1), select the
appropriate temperature setting for the pouch gauge thickness and
material you are laminating using the Up/Down Arrow keys.
Temperature Setting Guidelines
When laminating thin paper with light ink coverage, set the temperature
dial to the low end of the film gauge range. Thick paper with heavy ink
coverage requires higher settings within the range. Temperature settings
will vary due to the finish, chemistry and heat absorption properties
of the material being laminated. If the laminated pouch is cloudy after
the first pass through the machine, adjust the temperature to the next
higher position and run it through again. If waviness occurs, reduce the
temperature to the next lower position. Always allow sufficient time for
the laminator temperature to adjust to the changes made to the settings.
When the laminator has reached the correct lamination temperature
4
the countdown to ready will indicate "Ready" 0 minutes on the LCD
display.
Centre the item to be laminated within the pouch left to right with
5
the top edge against the sealed edge of the pouch (fig.2).
Insert the pouch with the sealed edge first into the machine (fig.3).
6
The laminated item will automatically exit at the rear of the machine.
7
After the pouch has stopped moving, carefully remove from the
machine and place on a cool flat surface for approximately one
minute for cooling (fig.4).
If you are finished laminating push the power switch to turn the
8
machine off.
Guarantee
Operation of this machine is guaranteed for two years from date of
purchase, subject to normal use. Within the guarantee period, ACCO
Brands Europe will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use for
inappropriate purposes are not covered under the guarantee. Proof
of date of purchase will be required. Repairs or alterations made by
Register this product online at www.accoeurope.com
Operation, cold lamination
Connect the power cord plug to the appropriate power source.
1
Push the power button to "ON" position. The LCD display will
2
illuminate (fig.1).
3 The LCD display will automatically default to the "0" * Temp.
position.
Follow the instructions included with your GBC self adhesive
4
laminate or other pressure sensitive, non thermal laminating
pouches.
Reverse feature
In the event of a misfeed or a jam follow these instructions.
1 Press the reverse button and hold down (fig.5). This will reverse
the rotation of the rollers allowing the pouch to exit the front of the
machine.
2 Pull the document out of the laminator.
3 After the document is out of the machine clean the rollers by
running the cleaning sheet through the laminator.
m
Caution: Use caution when removing the laminated pouch
from the machine. It may be hot.
persons not authorised by ACCO Brands Europe will invalidate the
guarantee. It is our aim to ensure that our products perform to the
specifications stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation governing
the sale of goods.
G