Installing Your Appliance; Proper Positioning; Building In - Blomberg MIN 5400 Guide D'installation Et D'utilisation

99635771.qxd 18/02/05

1 1 / INSTALLING YOUR APPLIANCE

6 6 . . 4 4
• • PROPER POSITIONING
Your appliance should be positioned so that
the plug-in unit is accessible.
The distance between the edge of your
appliance and the side and rear walls (or
partitions) must be at least four centimetres
(area A).
Your appliance can be easily integrated above
a cabinet, an oven or a build-in-ready
household appliance. You must simply ensure
that the air intakes and air outlets are clear
(See "Description of Your Appliance" section).
BUILD-IN
• •
Follow the diagram above.
Glue the foam seal underneath your appliance
by following the outline of the worktop upon
which your appliance will rest. This will allow
you to achieve an airtight seal with the
worktop.
Attach the clips to the hob.
14:44 Page 30
5 5 8 8 / / 7 7 7 7
4 4 9 9
A
hob, the hob's thermal safety measures
forbid the simultaneous use of the hob and
the pyrolysis program of your oven.
Your hob is equipped with an anti-
overheating safety device.
This safety can be activated, for example,
when the hob is installed over an oven that
is not sufficiently insulated. If this occurs, a
series of small lines appear in the control
panel. In this case, we recommend that you
increase the ventilation of your hob by
creating an opening in the side of your
cabinet (8 cm x 5 cm) and/or that you install
the oven insulation kit (reference 75X1652)
that is available from the Post-Sales Service
Department.
located under your cooking appliance
remain clear at all times.
For all types of installation, your induction
hob needs proper ventilation.
30
5 5 1 1
5 5 6 6 / / 7 7 5 5
Tip
If your oven is located below your
Warning
You must ensure that the air intakes