Makita DCL182 Manuel D'instruction page 5

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes too full, or the
•
suction force weakens.
Be sure to empty out the dust inside the cleaner
•
itself. Failure to do so may cause the sponge filter
to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
•
should be used whenever either the dust bag or the
dust pack is used.
1
2
011551
1. Push the button to open the front cover. Opening it
until a click is heard allows a positive stop at that
position.
011553
NOTE:
The cleaner is constructed in such a way that the
•
front cover comes off when trying to force the front
cover open at the angle of more than 90°. If the
front cover comes off, insert it into the front cover
joint in place.
CAUTION:
When closing the front cover, be careful not to
•
pinch your fingers.
1. Front cover
2. Button
1. Front cover
1
2. Front cover joint
2
1
011552
2. Pull out both the orange-colored dust stopper and
dust bag together at the same time.
1
008920
008921
3. Remove the dust stopper and empty the cleaner.
Dust bag and paper pack
Install either dust bag or paper pack before using cleaner.
Use the dust stopper when installing either dust bag or
paper pack.
Dust bag are usable many times repeatedly by cleaning it
out.
Paper pack is a throw-away type. Throw away the entire
paper pack without emptying when it has become full.
Installing dust bag
1
2
008930
Use the dust stopper when installing dust bag. Be careful
not to take the upper side for the lower side by mistake
5
1. Dust stopper
1. Dust stopper
1. Upper side of
dust stopper
2. Lower side of
dust stopper