Anti-Tip Bracket - Silhouette DWC047D1BSSPR Guide D'utilisation

Installation Instructions
PREPARING THE ENCLOSURE
• The rough cabinet opening must be on a level fl oor area and a minimum 25" (63.5 cm) deep by
24" (60.96 cm) wide and at least 34 9/16" (87.8 cm) high.
• The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear
of the shaded area.
• If the electrical outlet is located inside the adjacent cabinetry, cut a 1.5" (3.81 cm) diameter hole to
admit the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or
grommet.
Important: The listed depth requirement
for the installation is assuming that the
electrical outlet is located in the adjacent
cabinetry or is fl ush mounted in the rear
wall, not surface mounted in the enclosure.

ANTI-TIP BRACKET

This appliance may tip when shelves are extended,
causing damage, injury or loss of contents. If this
appliance is being used in a free standing application,
the anti-tip bracket must be installed on either the
back left or back right side of the unit.
Anti-tip bracket mounting holes:
A: Fixed mounting hole for unit
B: Fixed mounting holes for drywall
C: Fixed mounting holes for wood fl oor
D: Fixed mounting holes for concrete fl oor
E: Mounting holes on the back of the unit
E
1-1/2" dia. hole
*if electical outlet
is in adjacent
cabinetry
34-9/16" From
Underside of
Countertop to
Floor
Electrical Access
Pieces provided:
1. Anti-tip bracket
2. Bolt
3. Lock Washer
4. Flat Washer
5. Screws
6. Expansion Screws
A
6
25"
Min*
1-3/16"
6"
24" Min
1
5
B
C
D
E
Cabinets
Square
and
Plumb
2 3
4
6