Fitting The Oven Into The Kitchen Unit; Declaration Of Compliance; Product Description - Signature SFMC6X Instructions D'utilisation

12. If the cable is at all damaged it must be replaced promptly. When replacing the cable,
follow these instructions.
-Remove the power cable and replace it with one of the H05VV-F, and H05V2V2-F type .
-The cable must be able to bear the electrical current required by the oven.
-Cable replacement must be carried out by properly qualified technicians.
-The earthing cable (yellow-green) must be 10mm longer than the power cable.
13. Heating resistance temperature of power cord is above 70
connected with duplex switch,which is no less than 250V and 20A (no need to be connected
with plug).

3. FITTING THE OVEN INTO THE KITCHEN UNIT

Fit the oven into the space provided in the kitchen unit; it may be fitted underneath a work top
or into an upright cupboard. Fix the oven in position by screwing into place, using the two fixing
holes in the frame. To locate the fixing holes,open the oven door and look inside.To allow
adequate ventilation, the measurements and distances adhered to when fixing the oven.
IMPORTANT
If the oven is to work properly, the kitchen housing must be suitable. The panels of the kitchen
unit that are next to the oven must be made of a heat resistant material. Ensure that the glues
of units that are made of veneered wood can with stand temperatures of at least 120º C .
Plastics or glues that cannot withstand such temperatures will melt and deform the unit,once
the oven has been lodged inside the units, electrical parts must be completely insulated. This is
a legal safety requirement.All guards must be firmly fixed into place so that it is impossibl to
remove them without using special tools. Remove the back of the kitchen unit to ensure an
adequate current of air circulates around the oven. The hob must have a rear gap of at least
45 mm.

DECLARATION OF COMPLIANCE

When you have unpacked the oven, make sure that it has not been damaged
in any way. If you have any doubts at all, do not use it: contact a professionally
qualified person. Keep packing materials such as plastic bags, polystyrene,
or nails out of the reach of children because these are dangerous to children.

4. PRODUCT DESCRIPTION

Control panel
Door handle
Door
Triple-glass
window of
the door
C. The power cord should be
O
Function button
Clock button
Time button
4
- \ + selector
Start button
Stop button