Numark PT01 SCRATCH Guide D'utilisation page 4

Features
Top Panel
1. Power LED: This LED remains lit while the unit is powered on. To avoid wasting battery
power, make sure the power is off when storing or transporting the unit.
2. Platter: Place your record on the platter.
3. Tonearm: This is a ready-to-use pre-balanced tonearm and cartridge. The cartridge is
user-replaceable.
To play a record, unclip the tonearm clip, gently move the tonearm over your record on
the platter, and lower the tonearm onto the record. The platter starts spinning once the
tonearm is lifted over the record.
Important: Remove the plastic cover from the cartridge before using it.
4. Tonearm Clip: Use this clip to secure the tonearm when storing and transporting the unit.
5. RPM Selector: Use this switch to select the speed of the platter: 33⅓, 45, or 78 RPM.
Please select the appropriate setting for the record you are playing; if the music comes out
at an unusual pitch, this may indicate that the wrong RPM setting is selected.
6. 45 RPM Adapter: Use this adapter when playing 45 RPM records.
7. Pitch: Turn this knob to adjust the pitch of the music +10%. In the center position, the
pitch is 0%.
8. Tone: Turn this knob to adjust the low and high frequency audio levels.
9. Audio: Turn this knob to adjust the volume of the speaker, headphone outputs, and line
outs.
Note: Make sure the Audio knob is set to Off when connecting any alternate audio output
devices.
4
2
11
6
3
10
1 7 8 9
5
4