Mains Connection; Switching Off; Working Instructions - Toolland VL6000 Mode D'emploi

The small parts required for mounting are not included. Use the following for this purpose:
Place the device at a location that meets the following conditions:
 Secured against slipping
 Free of vibrations
 Even
 Clean and dry
 Free of tripping hazards
 Adequate light
7. Commissioning
7.1

Mains Connection

Compare the voltage listed on the device type plate with the mains voltage and connect the chain sharpener to
the corresponding and properly grounded socket.
Alternating current motor: Use a shockproof plug, mains voltage 230 V with residual current
circuit breaker and 10 A inert fuses.
Use a connection cable or extension cable respectively with a cross section of at least 1.5 mm³.
7.2 Switching On
Do not use any device where the switch cannot be switched on and off. Damaged switches must
be repaired or replaced immediately.
Press the on-off switch to I.
7.3

Switching Off

Press the on-off switch to O.
8.

Working Instructions

8.1 Before Commencing Work
 Workplace tidied?
 Has the chain sharpener been permanently mounted on a workbench?
 You may not start to operate the machine until you have read these operating instructions, observed all the
instructions given and installed the machine as described.
V. 01 – 05/06/2015
Position Description
1 hexagonal screw M8
2 washer Ø 8 mm
3 hexagon nut M8, self-locking
VL6000
7 ©Velleman nv