Possible Faults; General Guidelines - Toolland VL6000 Mode D'emploi

Note the following to keep your chain sharpener functioning:
 Clean and oil all moving parts regularly (except for the drive system).
 Remove dust and dirt with a cloth or brush.
 Clean the vent slots after each use.
 Clean the machine only dry.
 Do not use solvents for the synthetic parts (petrol, alcohol, etc.) as these can damage the
synthetic parts.
 Never use any grease! Use environmentally-acceptable spray oil.
11.2 Storage
Pull out the main plug.
 Store unused equipment in a dry, locked place out of the reach of children.
 Thoroughly clean the device before extended storage.
12.

Possible Faults

Before each fault clearance:
 Switch off the device
 Wait for the shutdown of the grinding wheel
 Pull out the main plug
Fault
Chain sharpener does not operate
Chain sharpener grinds with
interruptions
Grinding wheel becomes hot
Motor is humming, grinding wheel
stops
Unusual vibrations
13.

General Guidelines

Refer to the Velleman ®
14. Features
 5 cutting angles
 stone 100 x 10 x 4.5 mm (included)
 options (not included):
spare stone 100 x 10 x 3.2 mm (order n° EHBE777)
o
spare stone 100 x 10 x 4.5 mm (order n° EHBE999)
o
V. 01 – 05/06/2015
Possible cause
 No power
 Extension cable defective
 Main plug, motor switch
defective
 Extension cable defective
 Internal fault
 On-off switch defective
 Grinding wheel is dull or
defective
 Grinding wheel is blocked
 Grinding wheel is defective
Service and Quality Warranty on the last pages of this manual.
VL6000
10
Remedy
 Check power supply, power
socket and fuse protection
 Check extension cable,
exchange defective cable
immediately
 Have motor or switch checked
by an approved electrician or
replaced by original spare
parts
 Check extension cable,
exchange defective cable
immediately
 Please contact your official
dealer
 Please contact your official
dealer
 Replace the grinding wheel
 Remove object
 Replace grinding wheel
©Velleman nv