ProBreeze PB-AC05 Mode D'emploi page 9

Hinged Window Sealing Fabric
Assembly Installation
1. Open window and clean frame and
casement surfaces of dust and
particles.
2. Stick the velcro tape around the
entire window frame. Never stick
to the window seal as doing so will
prohibit the window from closing fully.
3. Stick the velcro tape around the
entire window casement (inside or
outside). Check to ensure the window
can close fully.
4. Attach side A of the sealing fabric
assembly to the velcro on the window
frame working from the centre
outwards.
5. Close and open window to ensure no
fabric gets trapped.
6. Attach side B of the sealing fabric
assembly to the velcro on the window
casement working from the centre
outwards.
7. Open the window slightly and
insert the heat exhaust hose short
connector into the sealing fabric
assembly securing with the zippers
around its lip.
8. The sealing fabric assembly is now
ready for use.
Notes:
•
Do not bend the heat exhaust hose in
excess of 45 degrees. It should be as
short and as straight as possible to
ensure efficient air flow.
•
Do not overstretch the heat
exhaust hose as this may affect the
appliances efficiency.
Frame
2 & 3
7
Hinged window sealing fabric zip
Side A
Casement
Side B
4 & 6
English | 09