Beta 1498TB/12 Mode D'emploi page 12

INSTRUCTIONS FOR USE
5. Press ▼▲ to select the battery test standards: CCA, SAE, DIN, JIS, IEC, EN, CA,
Unknown
Press "Enter" to confirm your choice.
6. Press ◄ ► ▼▲ to input the battery capacity of CCA
• CCA 100~1700
• SAE 100~1700
• DIN 100~1000
• JIS 100~1700 (see codes conversion table)
• IEC 100~1000
Press "Enter" to start the test.
7. The test will take a few seconds.
8. When the test has been completed, the display shows the current volts and CCA.
One of the following results will also be displayed:
Battery: Good:
The battery is good and holds the charge.
Battery: Recharge:
The battery is flat; the battery conditions cannot be determined correctly until it has been fully
recharged. Recharge & retest the battery.
Battery: Replace:
The battery does not hold the charge.
It should be replaced immediately.
9. Press "EXIT" to return to step 3, or remove the test clips from the battery posts to end the test.
12
• EN 100~1700
• CA 100~1700
• Unknown
EN
Select Rating▼▲
CCA – SAE – DIN
JIS – IEC – EN – CA
Unknown
Input Battery Rating
Increase/Decrease:
▲Single digit▼
◄By hundredth►
xxx CCA
Analysing...
Please wait!
Battery: Good
Measured: xxxA SAE
Rating: xxxA SAE
Volts:
Int. R: x.xx mΩ
Life: xx%
Battery: Recharge
Measured: xxxA SAE
Rating: xxxA SAE
Volts: xx.xx V
Int. R: xx.xx mΩ
Life: xx%
Battery: Replace
Measured: xxxA SAE
Rating: xxxA SAE
Volts: xx.xx V
Int. R: xx.xx mΩ
Life: xx%