GreenWorks Tools 4100302 Manuel D'utilisation page 7

4. Do not use force when inserting the battery pack. It
should slide into position and "click".(sold separately)
To remove (See Figure 2.)
1. Press the latch button (1) on the battery pack down and
hold.(sold separately)
pack out of the housing.(sold separately)
snugly in order to prevent accidental
dislodging. It may require a strong pull to
remove it.(sold separately)
Fig. 4
2
• Replace the battery pack or the charger immediately
if the battery case or charger cord is damaged.(sold
separately)
• Verify that the switch is in the OFF position before
inserting or removing the battery pack.(sold separately)
• Verify that the battery pack is removed and the switch
is in the OFF position before inspecting, adjusting, or
performing maintenance on any part of the blower.
•Read, understand, and follow the instructions contained
in the section entitled Charging Procedure.
•If a leak develops ,the released electrolytes are
corrosive and toxic. DO NOT get the solution in the eyes
or on skin ,and do not swallow it.
DO NOT place these batteries in your regular household
trash. The battery must be removed from the appliance
before it is scrapped.
STARTUP
1.Before each startup,make sure the power switch is in the OFF
position
3.Release pressure from the system. Drain moisture from the
air tank by slowly opening the air tank drain valve by turning
counterclockwise. Once all the moisture has drained out, close
the fitting securely.
3
4
WARNING
English
NOTE: Air tank will not pressurize while drain valve is
open.
4.Turn the pressure regulator knob fully counterclockwise to
5.Attach air hose and accessories.
Too much air pressure causes a hazardous risk
of bursting. Check the manufacturer's maximum
pressure rating for air tools and accessories.The
regulator outlet pressure must never exceed the
maximum pressure rating.
6.Insert the battery pack to the air compressor securely. (sold
separately)
7.Turn the compressor ON by moving the switch to the AUTO/
ON position and allow the tank pressure to build.Once the
air pressure reaches the maximum preset pressure("cut-out
"pressure) it will automatically shut off.
8.Slowly turn the pressure regulator knob clockwise to open
reached.
1
Fig. 5
AIR TANK
PRESSURE GAUGE
TOOL OUTLET
PRESSURE GAUGE
NOTE: The air compressor will automatically restart once
the pressure in the air tank drops below the minimum
preset pressure ( "cut-in" pressure).
Do not disassemble check valve, tank drain valves or
safety relief valve with air in tank — bleed tank. Failure
to depressurize tank could result in explosion and/or
serious personal injury.
Always wear eye protection with side shields. Failure to
do so could result in objects being thrown into your eyes
and other possible serious injuries.
7
WARNING
OPEN
DANGER
WARNING