HumanTechnik A-3222-0 Mode D'emploi page 7

Congratulations on purchasing your
lisa vibro time. You have selected a
modern and reliable system.
The lisa vibro time is an electronic
clock with an analogue time display.
It wakes you up using vibration
and/or an audible alarm (a vibrating
cushion is supplied with the pro-
duct). In addition, the lisa vibro time
has a receiver for the lisa signaling
system.
Standard components
- lisa vibro time
- vibrating cushion
- 230 V power supply unit
- Warranty card
Startup
Connect the supplied mains lead to
the socket on the alarm clock and
plug it into a 230 V power outlet.
Time setting
Carefully pull out the button for set-
ting the clock/alarm time and, with
the button pulled out, turn it in the
direction of the arrow until the desi-
red time is set.
Note: Please do not use excessive
force when pulling out the button for
setting the clock/alarm time!
Setting the wake-up time
Turn the button for setting the
clock/alarm time in the direction of
the arrow until the required alarm
time is set.
Switching on the wake-up alarm
Switch on the wake-up alarm using
the ON / OFF switch.
Switch not pressed: Wake-up alarm
switched on (green outline visible
around switch).
Switch pressed: Wake-up alarm
switched off.
Switching on the audible alarm
Switch on the audible alarm using
the Audible alarm ON / OFF switch.
Switch not pressed - Audible alarm
switched on (green outline visible
around switch).
Switch pressed: Audible alarm swit-
ched off.
Snooze Alarm
Press the Light/Snooze button to
suspend a wake-up alarm which is in
progress. The wake-up alarm is trig-
gered again after about 5 minutes.
Face illumination (back light)
Touching the Light/Snooze
Alarm/lisa signal cancel switch will
light the face.
Switching on the clock face illu-
mination
Press the Light/Snooze button to
switch on the clock face illumination
for about 4 seconds.
English 7