Service Schedule; Handover Confirmation; Service Confirmation - Stihl GHE 355 Manuel D'utilisation

Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
( 10.7)
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Replace fuse ( 10.1)
– Close feed chute properly and tighten
screws ( 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.4)
– Reset locking device ( 11.7)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
– Incorrectly ground blades
– Power cable too long
– Bent blade disc
Remedy:
– Replace or re-sharpen shredding
blades ( 11.9), ( 11.8)
– Sharpen blades correctly
0478 201 9914 B - EN
– Use shorter power cable (
– Check blade disc visually
Fault:
Branch material is not drawn in
Possible cause:
– Incorrect rotational direction of blade
disc
– Blunt or incorrectly ground blades
Remedy:
– Change rotational direction of blade
disc ( 10.7)
– Regrind combination blade and ensure
sharpening angle is exactly correct
( 11.9)
8.8),
Fault:
Feed chute cannot be fitted
Possible cause:
– Locking device is not released
Remedy:
– Release locking device (
( 11.9)
10.1)

19. Service schedule

19.1 Handover confirmation

11.7)

19.2 Service confirmation

Please hand this instruction manual
to your STIHL specialist dealer in
the case of maintenance operations.
He will confirm the service operations
performed in the pre-printed boxes.
Service performed on
Next service date
24
53