Vertical Alignment - HK Audio LUCAS 2K15 Mode D'emploi

●
12
Mains
Use the factory-included mains cord to connect this socket to a wall outlet.
Note: LUCAS 2K is equipped with a V-Lock mains socket. If you use a
Volex locking power cord or another optionally available brand with the
same design, you can fi x the power cord in place to prevent accidental
disconnection.
Caution! Make sure the local mains voltage matches the voltage
specifi ed on the LUCAS 2K subwoofer. Connecting it to the wrong mains
voltage may destroy its electronic components.
●
13
Satellite Input
Plug speaker cords no less than 1.5 mm² thick and equipped with Speakon®
NL2-compatible +1/-1 connectors into these speaker outputs to connect the
satellites to the subwoofer's Satellites Out (
LUCAS 2K
SATELLITE
Input
Serial No.
8 Ohms
300 W Program
3 Powering Up
• Make sure the mains cord is connected and the Power button (
to Off .
●
4
• Turn the Master ( ) knob all the way down to the far left.
• Connect the two satellites to the subwoofer.
• Switch on all components connected to LUCAS 2K.
●
• Then push the Power button (
Heads up: Always switch LUCAS 2K on last—that is, after powering up all
other components—and switch it off fi rst before powering down all other
connected devices.
Mixer
Left
LUCAS 2K
SATELLITE
Input 1 1 2
2
Serial No.
8 Ohms 300 W Program
LUCAS 2K
Satellite
LUCAS 2K
Subwoofer
●
11
) ports.
1
1 2
2
13
●
10
) to switch on the system.
Right
Input
L R
Thru
L R
Satellites Out
LUCAS 2K
L R
Satellite
4 Setting Up
4.1 Placement
The subwoofer needs to be centered between the two satellites for the
system to deliver a balanced stereo image.

4.2 Vertical Alignment

The MonoTilt™ pole mount's 3° angle ensures the satellites remain at their
center of gravity. This slight tilt also serves to better align the speakers to
the audience.
10
) is set
The MonoTilt™ pole mount's diameter is 36 mm so LUCAS 2K satellites can
be mounted on any standard speaker stand.
Heads up! Always place speaker stands on a stable, sturdy surface and
never exceed the manufacturer's load-bearing specifi cations.
Caution:
• Use only speaker stands that are stable enough to prevent accidental
tipping after satellites are mounted. Ensure the speaker stand is designed
LUCAS 2K
SATELLITE
to handle the satellite's weight. Adjustable stands' highest setting must
Input 1 1 2
2
Serial No.
300 W Program 8 Ohms
be limited so as to prevent the combination of speaker stand and satellite
from tipping. This applies when setting the stand on a fl at, horizontal
surface.
• When setting up on an uneven or sloping surface, make sure the speaker
stand's base is secured to prevent accidental tipping, either by attaching
suitable weights to the base or taking other safety measures.
• The use of any other fi xtures or fi ttings can result in instability that may
cause injury.
LUCAS 2K15/2K18 1.0
55°
–3°
5