Building The Appliance In Under A Worktop - Brandt USB 1400 E Mode D'emploi

Building the appliance in under a
worktop
The dimensions of the recessed installation area must
correspond with those indicated in the figure.
S.I.004
The appliance could be inserted between two units
(a) or as an end unit (b).
S.I.005
Important
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
UPPER
SUPER.
D326
1. Fasten the side panel to the rear of the appliance
with the fixing brackets.
a
b
LOWER
INFER.
22
UPPER
SUPER.
E
D319
2. Fasten the appliance to the worktop or the sides,
applying the sealing strip between the appliance
and adjacent cabinet using the fixing brackets (E).
S.I.006
3. The appliance is equipped with adjustable support
feet. To adapt the appliance to the height of the
installation area (max 870 mm), screw in, or screw
out the feet situated in the four bottom corners.
PR266
4. Separate parts A, B, C, D as shown in the figure.
LOWER
INFER.
E
B
A
C
D