Sony HT-S350 Mode D'emploi page 16

1
Prepare two screws (not supplied)
that are suitable for the wall
mount holes on the rear of the Bar
Speaker.
More than 30 mm
Hole on the rear of the Bar Speaker
2
Stick WALL MOUNT TEMPLATE
(supplied) on a wall.
Center of the TV
Adhesive tape,
etc.
1
Align TV CENTER LINE () of
WALL MOUNT TEMPLATE with the
center line of your TV.
2
Align TV BOTTOM LINE () of
WALL MOUNT TEMPLATE with the
bottom of your TV, then stick
WALL MOUNT TEMPLATE on a
wall by using a commercially
available adhesive tape, etc.
GB
16
4 mm
5 mm
10 mm
WALL MOUNT
TEMPLATE
3
Fasten the screws into the marks
() on SCREW LINE () of WALL
MOUNT TEMPLATE as in the
illustration below.
368.5 mm 368.5 mm
Screws
10 mm to
11 mm
4
Remove WALL MOUNT TEMPLATE.
5
Hang the Bar Speaker on the
screws.
Align the holes of the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
Note
When sticking WALL MOUNT TEMPLATE,
smooth it out fully.
Marks ()