Filling The Water Tank - TEFAL IS5510 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Fabric brush assembly

• Insert the fabric brush into the holes located on the

fig.10

steam head -

• Before removing the fabric brush, be sure the

appliance is unplugged and totally cool.

• Pull the brush out of the steam head to remove it.

TIP: Before using this accessory, check the

manufacturer recommendations. It is also

recommended that you carry out a test on part of

the fabric which cannot be seen.

IMPORTANT

Never use water that

contains additives

(starch, perfume,

aromatic substances,

softener, etc) in the

steamer. Additives

such as these can

affect the properties

of the steam and lead

to the formation of

deposits. Never use

water completely

distilled or

demineralized.

Use

• The steamer works with 2 alkaline LR44 batteries

(1,5V), they are included in the appliance. The

batteries need to be replaced between 2 and 4 years

depending on usage. To change the batteries,

remove the cover screws on the handle of the

steamer and place the batteries. Close the cover and

apply screws to secure it -

*Depending on the model: these accessories are specific to certain models or available as an option.

• Ensure that the steamer is unplugged -

Remove the water tank from the base of the

appliance by pulling the handle upwards -

Unscrew the tank cap and fill the tank -

tank holds 1.8 liters (60 ounces).

• The steamer must to be used with TAP WATER. If

the water in your area is hard, T-fal recommends

that you mix half tap water and half distilled water,

which reduces the hardness. You can also use

bottled spring water or distilled water only.

• After closing the cap, turn the tank down and hold

it by the handle. Check out that no water is leaking

through the cap.

• Place the water tank on the base -

have any difficulty to placing it, check that the

water tank is not the wrong way round.

fig.21