Daikin EKHH2E200AAV3 Manuel D'installation Et D'utilisation page 38

10 Troubleshooting
In case of problems of equipment performance, without
the occurrence of any of the alarms or errors described
in the relative paragraphs, it is advisable to check to
see if the problem can be easily solved by checking the
possible solutions specified in the table below prior to
seeking technical assistance.
Problem Possible causes
The heat pump does not There is no electricity;
work
The plug is not correctly
inserted in the socket.
The compressor and/or The set safety period of
the fan do not work time has not finished;
The scheduled
temperature has been
reached.
The heat pump Wrong programming of the
continuously switches parameters/setpoint and/or
itself on and off hysteresis values.
The heat pump remains Wrong programming of the
continuously switched on parameters/set point
and does not switch off and/or hysteresis values.
The electric heating Your intervention is not
element does not switch on required
WARNING!
In the event that the operator does not
succeed in solving the problem, switch off the
equipment and seek technical assistance
specifying the device model purchased.
Page 38
11 Disposal
At the end of their device lifecycle, the heat pumps will
be disposed of in conformity with the applicable
regulations.
WARNING!
This equipment contains greenhouse
fluorinated gas included in the Kyoto protocol.
The maintenance and disposal operations
must only be carried out by qualified
personnel.
INFORMATION TO USERS
Pursuant to Directives 2011/65/EU and 2012/19/EU,
relating to the reduction of the use of hazardous
substances in electric and electronic equipment as well
as waste disposal.
The symbol of the barred wheelie-bin that can be seen
either on the equipment or its packaging indicates that
the device must be collected separately from other
waste at the end of its lifecycle.
At the end of the device lifecycle, the user must
therefore take the equipment to suitable separate
collection centres for electronic and electro-technical
waste, or to return it to the dealer upon purchasing
another equivalent device, at the ratio of one to one.
The adequate separate waste
collection relating to the subsequent
sending of the discontinued
equipment for recycling, treatment
and/or environmentally-compatible
disposal, contributes towards
avoiding possible negative effects
on both the environment and health;
it also encourages the reuse and/or
recycling of materials of which the equipment is made.
The unlawful disposal of the device by the user leads to
the application of the administrative penalties foreseen
by applicable legislation.
The main materials that are used in the production of
the equipment are as follows:
Steel;
Magnesium;
Plastic;
Copper;
Aluminium;
Polyurethane.
Installation and user manual