GE GTH21 Série Manuel D'utilisation Et D'installation page 22

REVERSING THE DOOR SWING
REMOVE REFRIGERATOR DOOR
2
Tape the door shut with masking tape.
Remove the center hinge by removing two hinge
screws with a 5/16 socket and ratchet. Lift the hinge
pin up and out of the door.
NOTE: Do not misplace the washer located on the
underside of the center hinge pin.
Plastic Washer
Hinge Pin
Center Hinge
Bracket
Remove the tape and tilt the door away from the
cabinet. Lift the door straight up to free its bottom socket
from the pin in the bottom hinge bracket.
Set the door on a non-scratching surface with the inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
TRANSFER TOP HINGE TO
3
THE LEFT
Interchange hinge and screws at top right with screws
at the top left of cabinet.
Installation Instructions
Fresh Food Door
(CONT.)
TRANSFER BOTTOM HINGE BRACKET
4
TO THE LEFT
it about 6 from each end and pulling its bottom edge
toward you.
Using a 5/16 socket and ratchet, remove the 3 screws
from the bottom hinge. Taking care not to misplace the
washer on the bottom hinge, move the bottom hinge
from the right to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
Replace the base grille by inserting the tops of the metal
clips into the oval vents, making sure one of the plastic
tabs on the back of the grille goes into each of the oval
vents. Then push the bottom of the grille forward until it
snaps into place.
22
remove it by grasping
Plastic
Washer
Hinge
Bracket